RGBW BW Everything on a Stick LED lightstick for 3D Printers (5V)

I used this to make a progress bar on the bed of my Trident. It's working great.

IMPORTANT NOTE: These are NOT drop-in replacements for standard Disco or Daylight on a sticks. These sticks use 4-pin JST-PH with Din and Dout pins on each side, while Disco/Daylight use 3-pin JST-XH. You will need to re-pin your wires. The bolt hole placement is also slightly off because the LED density is higher.

These sticks are much improved over Disco sticks and sooooo much brighter. I appreciate the switch to 4-pin connectors to allow chaining off either side.

And if you don't know what the little switch on one side does, this is from Provok3d:
> Onboard switchable data line resistor for best data clarity (only use one per continuous string of LEDS)

This was exactly what I needed for my new enclosure for my printer. Provides good lighting for the camera on the gantry, and was easy enough to set up.