Voron Tap 5/24v compatible PCB OptoTap

Great little board!
Note: This is a revised version (V2.4) ...bad number for revision! ...gets mixed up with Voron V2.4.
I replace my V1.0 because I inadvertantly plugged it in wrong and cooked it. This new board fit right in mechanically with no mods. Upon power, I love the red/blue led indicator. Makes it very easy to see when it is triggered. I did have an issue. It did not trigger Klipper. My old V1.O board did just fine but this new one did not. I could not find a schematic to see what actually changed. I was able to verify that the output line was changing. On my system from tap down at 0.0v to around 1.34v tap up. I was also able to verify that the pin (PB9) on my EBB36 was working fine as well. I found that changing my printer.cfg settings from EBBCan:PB9 to ^EBBCan:PB9 did the trick. Adding that circumflex, Klipper's trick to use a pull-up resistor on the STM32G0B1CBT6 chip of the EBB36 took care of my issue. It's working great now.

The folks at West3D are the best in the business. Huge stock, quick to ship and always available on discord to answer questions and give advice.

The tap come as described work perfect in my trident