Mini-Fridge (Clicky-Clack) Door Kit for Voron V0.2 (LDO) - by TheVoronModder, Presented by West3D

Overall the hardware quality is solid and very well put together. The only real complaints come from some of the documentation not being clear (primarily around the alternative models you can print), and a tolerance issue with the tapped holes on the frame as another reviewer mentioned.

However, despite these issues, it is a great mod to install. The door is significantly more secure than the stock door assembly (which makes sealing the printer a lot easier), and it is a lot of fun to swing close the door and hear the latch click into place

Going off the exploded view on the github page it looks like the 4 m3x16's are what hold the door frame together. They are about 5 mm too long. Lets say 6mm so we can assume its m3x10's. Either I'm doing something wrong or the kit was shipped with the wrong screws/extrusions not tapped deep enough. I'll just use screws I have on hand but man is that a bummer.

The Parts included with the kit are fine, same quality extrusions as the V0 kit from LDO. The models for the printed parts leave room for improvement. Tolerances are a bit out of whack, I needed to make some changes to get them to fit properly and get a decent seal on the foam.