West3D Stainless Steel Fastener Kit for Voron 2.4 (BDF)

West3D's Stainless Steel Fastener kit for Voron 2.4 comes with all the fasteners (and extras of each in case a the screw monster eats one) you could need for your Voron 2.4 build. If you want the best damn fastener ("BDF") kit on the market, that won't make that beast of a printer you're building cry when its covered in rust, this is the kit you need. We carry these in both traditional 304 stainless steel, as well as 304 stainless that has gone through electrophoresis to add a wear resistant black coating on them (this is not black oxide which is gross). We have tested these fasteners against other suppliers, and even other sellers and can tell you definitively this is the best, and most complete kit on the market.

Below are a list of parts included, their quantities and associated material. 

If you are using a Misumi Frame our roll-in tnuts may not roll in, this is a known issue with these frames.

Note: we have upgraded these kits to work with both v2.4 R1 and R2 as well as afterburner/stealthburner.

We now include #4 3/8" screws for filtered inlets, and M3x8 BHCS for your building convenience. 

If you also need a hex key set, we've got you covered. See our set here. 

Please follow recommendations for the best threadlocker application for your use (Loctite® Threadlocker Blue 242 is what we recommend)

Please note the above table with BDF quantities is subject to slight variation over different iterations of releases - we are continually looking at ways to provide more extras to support mods people may decide to implement. You are guaranteed to have more than the BOM of each fastener through all iterations but the actual number of fasteners received may differ from the table provided above.