Elite Machined Ultralight X Beam with CNC XY Joints for Voron V2.4 and Trident with Titanium Hardware

I bought this for my 2.4 and love it. At the same time, I switched to CNC tap, purchased titanium fastners for the whole gantry, CNC A/B and upgraded to tool-less tensioners. I can't say that the improvement in printing from resonance becoming lower was all due to the beam, but it is very light, beautiful and is now in the cart for the Trident build I am doing.

The X beam and the related XY joints are well machined and nice looking but unfortunately the additional hardware (shoulder bolts and screws) are missing.
I contacted the support one week ago but haven’t gotten any reply yet.
Currently cannot install the parts...

The X beam and the related XY joints went in great, then at the very end I discovered that the X homing switch bracket of my Voron CNC Tap V2 held the switch just high enough that the switch crashed into the lower 5mm X beam mounting bolts and also the new XY joints didn't have a spot that would trigger the switch. So after a few revisions I solved the issue by printing an offset plate on the CNC Tap V2 that lowered the switch by 7mm and a new piece that attached using the two 5mm lower beam mounting bolts and provided a trigger point. You can see that in red hanging down in the picture. Aside from that and having to sand down two of the titanium shoulder bolts for the bearings and idlers to just barely slip on the install went very easily, I haven't done resonance testing yet.