PL-08N2 Inductive Probe

This probe works fine for a while, but will not last you forever.

Mine died after about 360 Hours -- I'm kind of thinking that the heat got it.

If the inductive probe is the route you are going, then go straight to the Omron TL-Q5MC2-Z from here on the West3D website. If you've got PIF printed parts and are moving to Tap or Klicky, then get this one and the appropriate hardware kit.

This probe works but is extremely inaccurate. I was getting ranges of 0.1 or more on klipper's probe_accuracy test, and over 0.025 is not accurate enough.